Weber PLATINUM SERIES 2 3200 NG Uživatelský manuál

PLATINUM™SERIES IINatural Gas BarbecuesStep-By-Step GuideNOTICE TO INSTALLER: These instructionsmust be left with the owner and the ownershould keep t

10You will need... left work surface, side burner assembly,four 1/4-20 x 1/2 inch bolts, four nylon washers and a7/16 inch or adjustable wrench.Insert

11Route the side burner hose so it will not interfere with thescale indicator rod.The side burner hose is connected in the followingmanner:Slide back

12Valves are shipped in the OFF position, but you shouldcheck to be sure. Put the knob on each valve. Check bypushing down and turning clockwise. Figu

13CHECK FOR GAS LEAKSFigure 25Figure 24Use a Phillips screwdriver to remove the screws from theunderside of the control panel. Figure 25.Stand at the

14CHECK FOR GAS LEAKSFigure 26(a)(b)(c)(d)(e)View from below(f)WARNING: Do not ignite burners while checking for leaks.Check for leaks by wetting the

REINSTALL THECONTROL PANELSet the control panel in place over both frame braces.(Hold the Crossover Ignition button up while setting thecontrol panel

2Gas line piping If the length of line required does not exceed 50 feet,use a 5/8" O.D. tube. One size larger should be usedfor lengths greater

3TOOLS NEEDEDPhillips screwdriver7/16 inch or adjustable wrenchSUPPLIES NEEDEDWhile we give much attention to our products, unfor-tunately an occasion

REMOVE GRILL FROMLOWER PACKAGINGMake sure natural gas hose is free from lower packagingbefore lifting.WARNING: Lifting the barbecue from the lowerpack

5INSTALLATION OF CATCHPAN INTO BOTTOM TRAYHook the ends of the catch pan holder into the hole in thebottom tray. Figure 4. The front of the catch pan

6Note: The cooking grates are already in place. Thisstepp is for reinstallation only.Set the cooking grates onto the ledges in the cookingbox. The ope

7INSTALL WARM-UPBASKETInsert one end of the Warm-Up Basket into the hole in theright end of the lid and the other end into the slot in theleft end of

8INSTALL WORKSURFACES FOR THE PLATINUM SERIES II 2200You will need...left work surface, right work surface, four1/4-20 x 1/2 inch bolts, four nylon wa

9Route the side burner hose around the tank panel so itwill not interfere with the scale indicator rod.The side burner hose is connected in the follow